In this project, we will use IR receiver VS1838B to decode the signal sent by any Infrared Remote controller(i.e.remote controllers for TV, DVD, Satellite box, and the IR controller with this kit etc).
Step 1 – Download IRremote Library, and then import the library into Arduino IDE(in Arduino IDE->Sketch->Import Library->Add Library)
Step 2 – Connect Arduino with IR Receiver
figure out the Signal-Out pin(left),Ground pin(middle) and VCC pin(right),connect Signal out pin to Arduino D10,Grand to Arduino GND and VCC to Arduino 5V as per following graph:
Step 3 – Download irdemo.ino sketch file, load it into Arduino.
Step 4 – Point the Remote controller to the flat side of IR receiver(the side with “VS1838B” printing), then push any key on the remote controller. click the serial monitor in the upright corner of IDE window. The monitor Window will show the code of the key you just pushed. see following graph:
You must be logged in to post a comment