KOOKYE Mini Servo Motor 360 Degree Continuous Rotation

Byamber

KOOKYE Mini Servo Motor 360 Degree Continuous Rotation

360 degree servo motor

Buy from US Buy from UK Buy from DE Buy from IT Buy from FR Buy from ES Buy from JP

A complete set of servo motor,include servo,rocker and screw,360 degree unlimited rotation. Multiple combination of gear set,it could apply to your needs,such as  remoto-control car ,model car, model robot,helicopter.

The signal terminal needs to be input with one 50 HZ square wave, then the duration of high level pulse, which is used to control signal cycle, can control speed and forward/backward rotation as well as stalling. The duration of high level corresponds to a speed. When high level is 1ms~1.5ms, servo rotates forward(the rotate speed is the fastest when it is 1ms, the higher the lower, servo will stop rotating when reaching 1.5ms). When high level is 1.5 ~2ms, the servo rotates backward(The servo stops rotating when reaching 1.5ms, when the duration is closer to 2ms, the closer, the faster. The backward rotation speed, the fastest when reaching 2ms)

This servo carries meso-position adjustment potentiometer(it can only be seen by peeling off the outer cover and circuit board). We can set high level pulse at 1.5ms to observe that whether servo stops rotating. If it doesn’t stop rotating, we keep adjusting the potentiometer until it does.

Specification:
Model: EAEC100300 DS04
Applies to model airplane / Model car / robot
Torque: 5.5kg/cm (at 4.8V)
Speed: 0.22sec/60°(at 4.8V)
Working voltage: 4.8v-6v DC
Temperature: 0℃-60℃
Current: < 1000mA Weight: 45g Dimensions: 1.57 x 1.61 x 0.78 inches (4 x 2 x 4 cm) White wire: Signal Red wire:VCC Black wire: GND The simple way to test the servo motor with arduino uno board: www.kookye.com/?p=6136

About the Author

amber administrator

3 Comments so far

JesusTMPosted on  5:01 am - Jul 10, 2018

Hi, reciently i bought 10 KOOKYE Mini Servo Motor 360 Degree Continuous Rotation, my problem is that i cant anticlockwise, i control the servos with arduino, with 1ms it go clockwise, with 1.5ms it stop, but with 2ms the motor sounds weird but not run in any way
Thanks for help.

    amberPosted on  10:42 pm - Jul 10, 2018

    Hi,you can try the following sketch, it should be OK.
    #include

    Servo servo1;

    void setup()
    {
    Serial.begin(115200);
    Serial.println(“:-]”);
    delay(300);
    }

    void loop()
    {
    servo1.attach(9); //*attaches the servo on pin 9 to the servo object
    servo1.writeMicroseconds(1300); //* 1300 between [1000,2000],the servo spin in one direction
    delay(3000); //*delay 3s
    servo1.detach(); //*disable the servo with arduino
    delay(3000);
    servo1.attach(9); //*attaches the servo on pin 9 to the servo object
    servo1.writeMicroseconds(1700); //*1700 between [1000,2000],the servo spin in another direction
    delay(3000);
    }

JesusTMPosted on  1:55 am - Jul 12, 2018

Thanks for the help, but they still do not work, I think they are defective, I will contact the seller. Thanks again.

You must be logged in to post a comment