Rasberry Pi Tank Robot Car Starter Kit Lesson 3:Installation of Tank Car Chassis

Byamber

Rasberry Pi Tank Robot Car Starter Kit Lesson 3:Installation of Tank Car Chassis


Robot Tank Car Chassis

Buy from US Buy from CA Buy from UK Buy from DE Buy from IT Buy from FR Buy from ES
amazon_ca

Youtube installation link: https://youtu.be/1etSCjePJrs

Objective:

Welcome to the first lesson of Arduino robot tank car!In this lesson, we will install the most important framework in the tank car.

Parts and Devices:

tank car accessaries

I.Installation

Step1: Assemble the carrying wheels(x10)
Main components:
1x black wheel
1x bearing
1x circle shaft
1x M6 nuts
1x M6*40 inner hexagon screws

I-1
I-2
I-3
I-4

Step2: Assemble the driving wheels(x2)
Main components:
2x wheel pieces
3x copper pillar
1x Al-alloy coupling
1x jackscrews
1x M6*10 inner hexagon screws
6x M3*10 inner hexagon screws

Note:
1)Please align the two location holes in the wheel pieces.
2)Install the jackscrews into the al-alloy coupling, then insert the al-alloy coupling into the big hole of driving wheel, fix the al-alloy coupling with M6 hex screws.
3)To fix the driving wheels on motors easily,do not tighten the jackscrews.

II-1
II-2
II-3
II-4

Step3: Install the main plate
Main components:
5x plates (include the base plate and subplates as following pictures)
20x M3*10 inner hexagon screws

Note:
Fix the biggest base plate with 4 pieces M3*10 screws for the first time, then fix the other subplates in turn as the following pictures.

III-1
III-2
III-3
III-4

step 4: Install motor
Main components:
2x side plates (include left side plate and right side plate)
2x motors
4x M3*5 screws (phillips head)

Note: When you fix the motor with phillips head screw, please do not use too long screw to avoid getting stuck.

IV

Step5: Install all wheels and tracks on car
Main components:
1x tank car chassis
10x carrying wheels
10x driving wheels
2x Tracks

Note:
1)To make the tracks install more easily, we recommend not to tighten the fifth carrying wheel and adjust the proper width between the driving wheel and side plate.
2)Please tighten the jackscrews with hex wrenches to connect the driving wheels to the motor.If the driving wheel is blocked by its jackscrew and cannot insert into motor axis, please slightly loosen the jack screw driving wheel.
3)Please choose the proper length tracks as per your need before install the tracks.

V-1
V-2
V-3
V-4

VI.The Finished Presentation
VI

VII. Packing List
Interface definition

Appendix for motor

GM25-370-motor specification
motor-01motor-02

About the Author

amber administrator

You must be logged in to post a comment