IntoRobot Nut ESP8266 Quick Start

Byamber

ESP8266 Wifi Module, IntoRobot ESP8266

IntoRobot Nut ESP8266 Quick Start

IntoRobot Nut Intruduction:

IntoRobot Nut is a tiny open-source Wi-Fi MCU board to develop IoT projects. It is easy to use, powerful and cost-effective.

IntoRobot Nut comes with access to the IntoRobot Cloud, a free cloud service. This loud has some great features for building connected projects, including over-the-air firmware updates and firmware development supported by web and local IDEs.

Tech Info:

• CPU ESP8266EX (Tensilica L106 32bit, 80 Mhz/160 Mhz) integrated with Wifi support
• 4 Mb Flash
• 50 Kb RAM
• DC 3.3V 800mA
• Wifi 802.11 B/G/N (2400 Mhz – 2483.5 Mhz)
• 9 x GPIO, 1 x I2C, 1 x SPI, 1 x I2S, 1 x Serial, 4 x PWM, 1 x A/D, 9 x external interrupt

Quick Start:

Step 1) Turn on power:

Connect a MicroUSB cable to the NUT board and turn on the power. If the RGB status LED shows light blue, it means your NUT is starting. If the LED turns flashing red, your NUT enters into Configuration Mode.。

If the RGB LED does not show flashing red, you need manually enter into configuration mode. Please push the Mode button on the side for 3 seconds. After the RGB LED should turn to flashing red, release the button. Your NUT is in Configuration Mode now.

Step 2) Read tutorial in following link , register an IntoRobot account and download APP

http://osoyoo.com/2016/11/13/intorobot_account

Step 3) Connect NUT to IntoRobot Cloud

Login to your IntoRobot account in your APP, click “添加设备” button in the upright corner，

1) The APP will remind you to put NUT board into Configuration Mode. If your NUT is not in Configuration Mode, go back to Step 1) .

2) Click “下一步”(NEXT) button in upright corner， go to “添加设备”(ADD DEVICE) page

3) Input the Wifi hotspot name and password . Make sure your cell phone is connected to Internet.

4) Click “配置”(Config) button and wait the system to config your device. It will take a while.

Once the configuration is done successfully, NUT RGB LED will show flashing white, your NUT is bound to your IntoRobot Account.

If configuration failed, RGB LED will keep flashing red, APP will show 配置失败( configuration failure).

If configuration failed, back to Step 1) and try again.

Step 4) Test NUT

If your NUT is configured successfully, your IntoRobot APP (or web control panel) will show a new device. Click that device , you can turn on/off User LED