Flashing LEDs


Flashing LEDs

This DIY project will tell you how to use Arduino to control LEDs and make them flashing.

The long leg of an LED is the positive leg, also called the anode. It should connect a digit Pin through 220 ohm resistor. The short leg is the negative leg, also called the cathode, must connect to ground.

Connection Graph:

Download the loop.ino sketch file, then load it into Arduino.

The six LEDs in the circuit will light in sequence, then in reverse.

About the Author

amber administrator

8 Comments so far

levitra 20mgPosted on  2:55 am - May 3, 2020

levitra coupon

buy levitra online no prescription usa – levitra for daily use free trial select language – levitra costa rica vbulletin solutions inc. all rights reserved.

viagra for salePosted on  10:11 pm - May 15, 2020

viagra for sale

levitra side effects levitra vs viagra gaestebuch.php – viagra information itrader – http://www.viagra.com

cialis onlinePosted on  2:57 am - May 20, 2020

generic cialis

cialis inurl:/aska.cgi – cialis tadalafil 20mg is for e-guest_sign.pl – cialis reviews side effects remember me?

viagra sexPosted on  4:45 pm - Jun 3, 2020

generic viagra online

viagra 5mg dosage legend – related:www.drugs.com/viagra.html viagra – does viagra work better than viagra cbbs.cgi?mode=

generic viagra for salePosted on  1:41 pm - Jun 21, 2020

viagra without doctor prescription

viagra viagra comparison – viagra and alcohol side effects you cannot reply to topics in this forum – groups viagra uk generic

viagra for salePosted on  11:09 pm - Jun 29, 2020

buy viagra online

viagra 20mg canada administrators – delta viagra – viagra sample

cialis otcPosted on  9:49 am - Aug 23, 2020

cialis over counter

cialis uk prices – cialis and alcohol consumption administrators – cialis spam filter ciallis

generic cialis at walmartPosted on  9:42 am - Aug 29, 2020

cialis walmart

genuine viagra cialis gel tabs best price buy online – viagra cialis please welcome our newest member: – cialis and alcohol mix it is currently

You must be logged in to post a comment